Set Up Protocol - ATT Nussbaum JUMBO LIFT 3200 NT Instrucciones De Servicio

14

Set up protocol

i After successful set up, complete this form fully, sign it, make a copy and send to the manufacturer
within a week.
Otto Nußbaum GmbH & Co.KG
Korker Straße 24
D-77694 Kehl-Bodersweier
The system with serial number ____________________was set up on (date) ____________________at
(company name) ________________________________________ in (town, city)_____________________
________checked for function and safety and put into operation. .
The set up was done by the operating company / specialist (score out the one that does not
apply).
The operating company confirms proper system set up, has read and will comply with all infor-
mation contained in this operating manual and inspection book, and will keep this document
accessible to trained operators at all times.
The specialist confirms proper system set up, has read all information in this operating manual and
inspection book, and has transferred the documents to the operating company.
____________________
Date
____________________
Date
Service partner: ______________________________________________________________________
Only fill out if the system has a fixed anchor.
Anchor used *)_____________________________________
Minimum anchor depth *) complied with: __________ mm
Tightening torque *) complied with:
*) See 4.2.1 selecting the anchor
20110009 OPI Version 1.0
________________________________________
Name, Operating company & company stamp
________________________________________
Name, Specialist
Type/ brand
__________ Nm
JUMBO LIFT 3200 NT - HYMAX XX 3200 PH
________________________
Operating company signature
________________________
Stamp
Specialist signature
75