Assembling sequence
1. Front guard
2. Blade
3. Blade screw
Mounting the rear guard
Mount the Rear Guard on to the motor housing and secure it with the locking nut.
Mounting the blade
Insert the blade onto the motor shaft.
Mounting the front guard
Hold the front guard to make sure that the trademark is level and that the front guard are centered over the rear
guard. Then push all the safety clips firmly into place.
Caution
1. Do not plug the power cord into the wall outlet until the fan has been completely assembled.
2. Use power source according to the electric specifications in the rating label at the back of switch box.
3. Never operate the fan with a cracked or damaged blade.
How to use
Speed control
The fan speed is controlled by the buttons on the base
To turn on the fan, simply press the button marked 1-2 to choose the speed, to turn it off, press the switch marked
"0"
Oscillation
Push down the oscillation knob and the fan will oscillate.
Pull up the knob, the fan will not oscillate.
Tilting adjustment
Always switch the fan off before making a tilt adjustment.
The air flow can be adjusted upward or downward by simply moving the fan guard up or down.
4. Rear guard
5. Motor housing
6. Oscillating control bar