Descargar Imprimir esta página

EuroLite BS-50 Manual Del Usuario página 17

Publicidad

Idiomas disponibles

Idiomas disponibles

Before rigging make sure that the installation area can hold a minimum point load of 10 times the device's
weight.
When installing the device, make sure there is no highly-inflammable
material (decoration articles, etc.) within a distance of min. 0.5 m.
Mount the device to your trussing system using an appropriate clamp.
For overhead use, always install a safety-rope that can hold at least 12 times the weight of the fixture. You
must only use safety-ropes with quick link with screw cap. Pull the safety-rope through the attachment eyelet
on the rear panel of the device and over the trussing system or a safe fixation spot. Insert the end in the
quick link and tighten the safety screw.
The maximum drop distance must never exceed 20 cm.
A safety rope which already hold the strain of a crash or which is defective must not be used again.
Adjust the desired inclination-angle via the mounting-bracket and tighten the fixation screws.
Connect the fixture to the mains with the power-plug.
The occupation of the connection-cables is as follows:
Cable
Pin
Brown
Live
Blue
Neutral
Yellow/Green
Earth
The earth has to be connected!
In general, lighting effects should not be connected to dimming-packs.
Before taking into operation for the first time, the installation has to be approved by an expert!
Master/Slave-operation
The master/slave-operation enables that several devices can be synchronized and controlled by one master-
device.
On the rear panel of the BS-50 you can find three XLR-jacks (Out) and an XLR-plug (In), which can be used
for connecting the devices.
The master-device controls all other slave-devices, which are to be connected to the master-device via a
balanced microphone lead. Connect the OUT-jack with the IN-plug of the next device.
OPERATION
After you connected the effect to the mains, the BS-50 starts running.
Sound-control/Master/Slave-operation
The lamp is automatically ignited as soon as the condensor microphone receives music signals.
You can do without a controller as the BS-50 features a built-in microphone, which provides automatic sound
control.
DANGER OF FIRE!
International
L
N
DANGER TO LIFE!
17/35
51806243X18NXS_V_1_0.DOC

Publicidad

loading