Installing The Paper Roll - Sharp XE-A301 Manual De Instrucciones

Installing the paper roll

Caution: The paper cutter is mounted on the printer (receipt side). Be careful not to cut yourself.
Installing the receipt paper roll:
Installing the journal paper roll:
When you want to manually install a new roll of paper while the machine is turned off, follow the
steps shown below:
1.
Pull the print head release lever toward you (to the head-up position). (Refer to the diagram on page 70.)
2.
Correctly place the new paper roll into the paper roll cradle of the receipt/journal side.
3.
Insert the paper end into the printer until it comes out of the printer.
4.
Cut or roll the paper onto the take-up spool as described above.
5.
Return the print head release lever to its original position.
72
8.
Remove the outer side of the take-up spool as shown
on the left.
9.
Remove the printed journal roll from the take-up spool.
1.
Turn the mode switch to the REG position with the power cord connected.
2.
Remove the printer cover.
3.
Check that the print head release lever is in the printing position.
4.
Set the paper correctly in the paper roll cradle of the receipt side.
5.
Insert the end of the paper into the paper chute of the printer until it is caught
by the printer auto-feed and comes out of the top of the printer.
If the printer does not catch the paper, feed the paper while pressing the
key.
6.
Cut off the excess paper using the paper cutter, and replace the printer
cover.
1.
Turn the mode switch to the REG position with the power cord connected.
2.
Remove the printer cover.
3.
Check that the print head release lever is in the printing position.
4.
Set the paper correctly in the paper roll cradle of the journal side.
5.
Insert the end of the paper into the paper chute of the printer until it is caught
by the printer auto-feed and comes out of the top of the printer.
If the printer does not catch the paper, feed the paper while pressing the
key.
6.
Insert the end of the paper into the slit in the paper spool. (Press the
key to feed more paper if required.)
7.
Wind the paper two or three turns around the spool shaft.
8.
Set the spool on the bearing, and press the
in the paper.
9.
Replace the printer cover.
}
key to take up excess slack
{
}
}