SOMFY TILT ONLY 50 WF ZIGBEE Instrucciones página 8

EN
2.5.3.Checking the direction of rotation
Press the Up button on the control point:
a] If the slats tilt in the desired direction, the direction of rotation is correct: move
onto section Setting the end limits and pairing the control point.
b] Otherwise: move onto the next step.
b1] Press the my button on the control point until the slats move up and down: The
direction of rotation has been modified.
b2] Press the Up button on the control point to check the direction of rotation of
slats.
2.5.4.Setting the end limits and pairing the control point
NOTICE
The end limits can be set in any order.
CAUTION
Do not set an end limit in a position that could lift the motorised product as this could result in long-term damage to
the motorised product and/or the drive.
1] Press and hold the Up button to tilt the slats to the desired up position. If
necessary, adjust the up position using the Up or Down buttons.
2] Press the my and Down buttons simultaneously until the slats briefly move up
and down.
ð The upper end limit is memorised.
3] Press and hold the Down button to tilt the slats to the desired lower position.
If necessary, adjust the lower position using the Up or Down buttons.
4] Press the my and Up buttons simultaneously until the slats briefly move up
and down.
ð The lower end limit is memorised.
▪ To confirm and exit the setting and pair the control point: briefly press the
PROG button of the control point:
◦ → The slats briefly move up and down: the drive is now set and can be
controlled using the control point.
▪ To confirm and exit the setting without pairing the control point: press and
hold the Up and Down buttons on the control point simultaneously, until the
feedback LED on the control point stops flashing.
◦ → The drive is now set and no control point is paired. (To pair the first control
point with an already set drive, refer to the following section).
2.5.5.Pairing the first control point to an already set drive
CAUTION
This procedure cannot be performed on multiple drives at the same time.
NOTICE
Keep the control point close to the drive during the whole procedure.
8
b1]
1]
3]
©
Copyright 2023 SOMFY ACTIVITES SA. All rights reserved.
TILT ONLY 50 WF ZIGBEE
]
a
]
b
b2]
2]
4]