SOMFY TILT ONLY 50 WF ZIGBEE Instrucciones página 11

TILT ONLY 50 WF ZIGBEE
1] Press and hold the PROG button on the control point until the slats briefly
move up and down.
2] Briefly press the Up and Down buttons simultaneously on the control point :
ð The slats briefly move up and down after a few seconds.
3] Press and hold the Up or Down button on the control point to tilt the slats to
the new desired upper position.
4] Briefly press the my and Down buttons simultaneously on the control point :
ð The slats move up and down.
ð The upper end limit is readjusted.
5] Press and hold the Up or Down button on the control point to tilt the slats to
the new desired lower position.
6] Briefly press the Up and my buttons simultaneously on the control point :
ð The slats move up and down.
ð The lower end limit is readjusted.
7] To confirm and exit the setting, press and hold the Up and Down buttons on
the control point simultaneously, until the feedback LED on the control point
stops flashing.
2.5.9.Advanced settings
Some advanced settings such as adjusting the speed or the tilting travel cannot be made with a control point.
These advanced settings can only be made via the TaHoma pro application, please refer to chapter Commissionning with
TaHoma pro application (recommended).
2.6.Tips and advice on installation
2.6.1.Questions about the product?
Observations
The motorised product does not work. The drive is neither set nor paired.
©
Copyright 2023 SOMFY ACTIVITES SA. All rights reserved.
Possible causes
The drive is paired but not set.
The drive is set but not paired
An obstacle hinders the movement of
the slats.
There may be some radio interference. Disconnect the power supply cable,
The drive battery is low and requires
charge.
The control point battery is low.
The control point is not compatible or
not programmed
1] 2]
3] 4]
5] 6]
7]
Solutions
Proceed to Commissioning of a
Zigbee drive.
Proceed to Commissioning of a
Zigbee drive.
Proceed to Commissioning of a
Zigbee drive.
Remove the obstacle.
then reconnect the battery to the drive.
Plug in the charger.
Check the battery power level and
replace if necessary.
Check the compatibility or pair the
control point as required referring to
Commissioning of a Zigbee drive.
EN
11