SOMFY TILT ONLY 50 WF ZIGBEE Instrucciones página 10

EN
1] Press and hold the PROG button on the control point until the slats briefly
move up and down.
2] Briefly press the Up and Down buttons simultaneously on the control point :
ð The slats briefly move up and down after a few seconds.
3] Press and hold the Up or Down button on the control point to tilt the slats to
the new desired position.
4] Briefly press the my and Down buttons simultaneously on the control point :
ð The slats move up and down.
5] To confirm and exit the setting, press and hold the Up and Down buttons on
the control point simultaneously, until the feedback LED on the control point
stops flashing.
2.5.8.2. Readjusting the lower end limit
NOTICE
Keep the control point close to the drive during the whole procedure.
1] Press and hold the PROG button on the control point until the slats briefly
move up and down.
2] Briefly press the Up and Down buttons simultaneously on the control point :
ð The slats briefly move up and down after a few seconds.
3] Press and hold the Up or Down button on the control point to tilt the slats to
the new desired position.
4] Briefly press the Up and my buttons simultaneously on the control point :
ð The slats move up and down.
5] To confirm and exit the setting, press and hold the Up and Down buttons on
the control point simultaneously, until the feedback LED on the control point
stops flashing.
2.5.8.3. Readjusting the two end limits
NOTICE
Keep the control point close to the drive during the whole procedure.
10
1]
3]
5]
1]
3]
5]
©
Copyright 2023 SOMFY ACTIVITES SA. All rights reserved.
TILT ONLY 50 WF ZIGBEE
2]
4]
2]
4]