Replacing the fuse
If the lamp burns out, the fine-wire fuse of the device might fuse, too. Only replace the fuse by a fuse of
same type and rating.
Before replacing the fuse, unplug mains lead.
Procedure:
Step 1: Unscrew the fuseholder on the rearpanel with a fitting screwdriver from the housing (anti-
clockwise).
Step 2: Remove the old fuse from the fuseholder.
Step 3: Install the new fuse in the fuseholder.
Step 4: Replace the fuseholder in the housing and fix it.
Should you need any spare parts, please use genuine parts.
If the power supply cable of this device becomes damaged, it has to be replaced by a special power supply
cable available at your dealer.
Should you have further questions, please contact your dealer.
TECHNICAL SPECIFICATIONS
Power supply:
Power consumption:
DMX-control-channels:
DMX-512-connection:
Flash-rate:
Colour-wheel:
Rotating gobo-wheel:
Outside diameter of the gobos:
Image diameter of the gobos:
Length of base (including handles):
Width:
Height (head horizontal):
Weight (net):
Maximum ambient temperature T
Maximum housing temperature T
Min.distance from flammable surfaces:
Min.distance to lighted object:
Fuse:
Accessory:
SYLVANIA BA250/2 SE D 90V/250W GY-9.5
GE CSD250/2 95V/250W GY-9.5 2000h 8500K
PHILIPS MSD250/2 90V/250W GY-9.5 2000h
OSRAM HSD250/80 90/250W GY9.5 3000h 8000K
FUTURELIGHT CP-240 controller
FUTURELIGHT CP-256/64 controller 16bit
FUTURELIGHT CP-512/64 controller 16bit
Wizard-512 USB DMX-Software + Interface
Wizard-1024 USB DMX-Software + Interface
FUTURELIGHT DES-3 DMX-terminator 3-pin
Please note: Every information is subject to change without prior notice. 05.09.2007 ©
230 V AC, 50 Hz ~
700 W
15/13
3-pin XLR
10 Hz
9 dichroic filters and open
6 interchangeable gobos and open
27 mm
23 mm
400 mm
410 mm
490 mm
25 kg
:
45° C
a
(steady state):
65° C
B
0.5 m
0.5 m
T 4 A, 250 V
No. 89106120
No. 89106100
No. 89106115
No. 89106210
No. 51834265
No. 51834288
No. 51834295
No. 51860102
No. 51860110
No. 51834001
36/68
00025523.DOC, Version 1.2