Replacing The Fuse; Technical Specifications - Futurelight EYE-18 Manual Del Usuario

Replacing the fuse

If the fine-wire fuse of the device fuses, only replace the fuse by a fuse of same type and rating.
Before replacing the fuse, unplug mains lead.
Procedure:
Step 1: Unscrew the fuseholder on the rearpanel with a fitting screwdriver from the housing (anti-
clockwise).
Step 2: Remove the old fuse from the fuseholder.
Step 3: Install the new fuse in the fuseholder.
Step 4: Replace the fuseholder in the housing and fix it.
Should you need any spare parts, please use genuine parts.
If the power supply cable of this device becomes damaged, it has to be replaced by authorized dealers only
in order to avoid hazards.
Should you have further questions, please contact your dealer.

TECHNICAL SPECIFICATIONS

Power supply:
Power consumption:
DMX-control-channels:
DMX-512-connection:
Flash-rate:
Length of base:
Width of yoke:
Height (head horizontal):
Weight:
Maximum ambient temperature t
Maximum housing temperature t
Min.distance from flammable surfaces:
Min.distance to lighted object:
Fuse:
Recommended controllers:
FUTURELIGHT CP-240
FUTURELIGHT CP-256/32
FUTURELIGHT CP-528
Wizard-512 USB DMX-Software + Interface
Wizard-1024 USB DMX-Software + Interface
Please note: Every information is subject to change without prior notice.11.08.2005 ©
230 V AC, 50 Hz
80 W
12
3-pin XLR
18 Hz
290 mm
290 mm
350 mm
8,5 kg
: 45° C
a
60° C
(steady state):
B
0.3 m
0.3 m
F 2 A, 250 V
No. 51834265
No. 51834286
No. 51834315
No. 51860102
No. 51860110
42/80
EYE-18 EYE-36
230 V AC, 50 Hz
135 W
12
3-pin XLR
18 Hz
290 mm
290 mm
360 mm
9,0 kg
45° C
60° C
0.3 m
0.3 m
F 2 A, 250 V
No. 51834265
No. 51834286
No. 51834315
No. 51860102
No. 51860110
51841300_V_1_2.DOC