Descargar Imprimir esta página

Parkside PHKSAP 20-Li A1 Traducción Del Manual Original página 22

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 83
Figure C:
Battery level indication light
21
Release button
22
Battery level button
23
Rapid battery charger
24
Charging status LED – Green
25
Charging status LED – Red
26
Scope of delivery
Q
1 Cordless circular saw 20 V PHKSAP 20-Li A1
1 Battery pack PHKSAP 20-Li A1-1
1 Rapid battery charger PHKSAP 20-Li A1-2
1 Rip fence
1 Hex key
1 Instruction manual
Technical data
Q
Cordless circular saw: PHKSAP 20-Li A1
Rated voltage:
No load speed n
:
0
Saw blade diameter:
Arbour diameter:
Max. cutting depth:
Battery pack:
Type:
Rated voltage:
Capacity:
Number of cells:
Rapid battery charger: PHKSAP 20-Li A1-2
INPUT:
Rated voltage and
frequency:
Power consumption:
OUTPUT:
Rated voltage:
Charging current:
Charging time:
Protection class:
24 GB / IE
20 V
4500 min
-1
190 mm
20 mm
90°: 62 mm
45°: 45 mm
PHKSAP 20-Li A1-1
Lithium ion
20 V
max.
5 Ah
10
100 – 240 V
,
50 – 60 Hz
95 W
14.4 – 20 V
4 A
approx. 90 min
II /
Noise emission value:
Noise measurement value determined in
accordance with EN 60745. The A-rated noise
level of the product is typically as follows:
Sound pressure level L
pA
Uncertainty K
:
pA
Sound power level L
:
WA
Uncertainty K
:
WA
Vibration emission value:
Total vibration values (vector total of three directions)
determined in accordance with EN 60745:
Cutting wood
(main handle)
Hand/arm vibration a
h,W
(auxiliary handle)
Hand/arm vibration a
h,W
Uncertainty K
WARNING!
The vibration level varies in accordance
u
with the use of the power tool and may
be higher than the value specified in these
instructions in some cases. There is a risk of
underestimation of the vibration load if the
power tool is used regularly in this manner.
Try to keep the vibration loads as low as
possible. Measures to reduce the vibration
load are, e.g. wearing gloves and limiting the
working time. Wherein all states of operation
must be included (e.g. times when the power
tool is switched off and times where the
power tool is switched on but running without
load).
NOTE
The vibration level specified in these
u
instructions has been measured in
accordance with a standardised measuring
procedure specified in EN 60745 and can
be used to make equipment comparisons.
The specified vibration emission value can
also be used to make an initial exposure
estimate.
:
89.4 dB(A)
3 dB
100.4 dB(A)
3 dB
: 3.65 m/s
2
: 2.97 m/s
2
1.5 m/s
2

Publicidad

loading