cecotec BAKE&FRY 2500 TOUCH STEEL Manual De Instrucciones página 22

ENGLISH
piece missing or in bad conditions, contact the Technical Support Service of Cecotec
immediately.
- Clean the interior and the exterior of the device with a damp cloth. Do not wet the heating
element.
- Clean the accessories thoroughly with hot water, detergent and a non-abrasive sponge.
- Dry all accessories and reassemble them inside the device.
- Do not fill the device with oil or any other liquid.
- Place the device on an even, heat-resistant surface.
- Keep a distance of at least 110 mm between the power socket and the wall, furniture, etc.
Box contents
- Oven
- Oven rack
- Baking tray
- Air fry tray
- Rotisserie
- Rotisserie handle
- Fat-drip tray
- Pizza stone
- Instruction manual
Tip
Before using the oven for the first time, follow these steps. You may detect a small amount of
smoke and odour, which is normal and does not imply any malfunction.
Remove all the accessories of the device and close the door.
1.
Plug the oven to a power supply.
2.
Set the temperature at 230ºC for 10 minutes to sterilise it and remove any unpleasant
3.
smells from the manufacturing process.
Features
The device features an open door sensor. This means that, when you open the door, the cooking
process will pause and the light turns on. The word 'Open' will appear on the display. When you
close the door, the cooking process will resume.
3. OPERATION
The oven-fryer features 9 pre-set programmes, fan function, rotisserie function and
preheating. Next, you will find a quick operation guide for the device operation and all the
buttons on the control panel.
Quick operation guide
Plug the device to the mains supply and on a flat and stable surface. Avoid placing the
1.
device near walls, so the ventilation is better.
Press the ON/OFF icon (14) and the control panel will automatically light up and the time
2.
and temperature indicators will show '- - -'.
42 BAKE&FRY 2500 TOUCH STEEL
Select one of the 9 pre-set functions. If the pre-set configuration does not suit you,
3.
you can modify the time and temperature. Moreover, you can add the fan or rotisserie
functions to the cooking process.
If you wish to preheat the device, press the icon 16 and the device will automatically start
4.
the preheating; once it is finished it will emit a sound and it will start the selected cooking
function. If you do not wish to preheat the device, press the Start/Pause icon (21) after
selecting the function.
When the cooking process finishes, the device will emit a sound to inform you.
5.
Press the ON/OFF icon (14) to finish the cooking.
6.
Warning
The device will enter the standby mode after approximately a minute of inactivity. To start the
device again, press the ON/OFF icon (14).
Control panel
Fig. 2.
ON/OFF (14)
Press this icon to turn the device on and off.
Pre-set functions (15)
This device has 9 pre-set functions that are shown in the table below.
ENGLISH
BAKE&FRY 2500 TOUCH STEEL 43