Sauder Cannery Bridge Serie Instrucciones De Montaje página 25

Step 16
å
1 - Fasten two TIE PLATES (7) to the back edges of the ENDS (A
st
and B). Use four 3/4" PAN HEAD SCREWS (14).
å
There are no pre-drilled holes in the back edges of the base unit.
å
2 - Drill a 1/8" hole through each of the bottom holes in the TIE
nd
PLATES and into the back edges of the base unit.
å
3 - Fasten the TIE PLATES (7) to the base unit. Use four 3/4" PAN
rd
HEAD SCREWS (14).
B
429512
A
1
st
7
www.sauder.com/service
14
3/4" PAN HEAD SCREW
(8 used in this step)
Electric drill with 1/8" bit
2
nd
and
3
rd
Fasten the TIE PLATE
to the base unit.
Page 25