Sauder Hammond Serie Instrucciones De Montaje página 10

Step 4
å
Separate six EXTENSION SLIDES (2) from the EXTENSION RAILS (1) as shown in the upper diagram below.
Be prepared, the parts are greasy.
å
Fasten six EXTENSION RAILS (1) to the LEFT END (C) and RIGHT END (D). Use eighteen BLACK 5/8" FLAT HEAD
SCREWS (25).
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the 1st hole shown in the diagram. Then, slide the inner
cartridge of the EXTENSION RAIL in to find the other holes that lines up with the holes in the ENDS. Turn a SCREW
into these holes.
å
NOTE: The EXTENSION SLIDES will be used later for the DRAWERS.
2
Push the release lever up and pull the SLIDE from the RAIL.
BLACK 5/8" FLAT HEAD SCREW
(18 used in this step)
Closed end
Page 10
25
1
1
1
D
www.sauder.com/service
1
Use these holes.
1
1
1
The CAM SCREW
must be here.
7
Closed end
1 hole
st
Closed end
C
428246