Sauder Hammond Serie Instrucciones De Montaje página 11

Step 5
å
Separate six EXTENSION SLIDES (2) from the EXTENSION RAILS (1) as shown in the upper diagram below.
Be prepared, the parts are greasy.
å
Fasten six EXTENSION RAILS (1) to the LEFT UPRIGHT (E) and RIGHT UPRIGHT (F). Use eighteen BLACK 5/8" FLAT
HEAD SCREWS (25).
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the 1st hole shown in the diagram. Then, slide the inner
cartridge of the EXTENSION RAIL in to find the other holes that lines up with the holes in the UPRIGHTS. Turn a
SCREW into these holes.
å
NOTE: The EXTENSION SLIDES will be used later for the DRAWERS.
å
Repeat this step to fasten one WIDE EXTENSION RAIL (31) to each UPRIGHT (E and F).
EXTENSION RAIL/SLIDE SET
2
Push the release lever up and pull the SLIDE from the RAIL.
WIDE EXTENSION RAIL/SLIDE SET
32
Push the release lever up and pull the SLIDE from the RAIL.
1
E
Closed end
1
1
1
428246
1
1
Closed end
Closed end
F
www.sauder.com/service
Use these holes.
Use these holes.
25
BLACK 5/8" FLAT HEAD SCREW
(26 used in this step)
Closed end
1
1 hole
st
Closed end
31
Closed end
31
E
31
F
7
Closed end
Page 11