Sauder Hammond Serie Instrucciones De Montaje página 23

Step 17
1
BLACK 1/2" FLAT HEAD SCREW
(12 used in this step)
2
X
å
Fasten the EXTENSION SLIDES (2) to the DRAWER
SIDES (X and Y). Use six BLACK 1/2" FLAT HEAD
SCREWS (27). Use the exact holes shown in the upper view.
3
Y
AA
å
Slide the DRAWER BOTTOM (V) into the grooves in the
DRAWER SIDES (X and Y) and DRAWER BACK (AA).
428246
2
27
Open end
2
Y
With the palm of
your hand, tap
the DRAWER
BOTTOM down
into the grooves.
V
X
2
These
holes
must be
here.
å
Fasten the DRAWER SIDES (X and Y) to the DRAWER
BACK (AA). Use four BLACK 1-3/8" FLAT HEAD
SCREWS (22).
4
X
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
å
Fasten the DRAWER FRONT (W) to the DRAWER
SIDES (X and Y). Tighten four HIDDEN CAMS.
å
Fasten a KNOB SET (9) to the DRAWER FRONT (W). Use a
BLACK 1/2" MACHINE SCREW (29).
å
Repeat this step for the other drawer.
www.sauder.com/service
BLACK 1-3/8" FLAT HEAD SCREW
(8 used in this step)
AA
Y
BLACK 1/2" MACHINE SCREW
(2 used in this step)
Y
22
X
Groove
29
1
W
9
Page 23