Sauder Manhattan Gate Serie Instrucciones De Montaje página 8

Step 2
å
Separate the EXTENSION SLIDES (6) from the EXTENSION RAILS (5) as shown in the
upper diagram below. Be prepared, the parts are greasy.
å
Fasten one EXTENSION RAIL (5) to the UPRIGHT (E). Use three 3/8" PAN HEAD
SCREWS (23) in the exact holes shown.
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged
diagram. Then, slide the inner cartridge of the EXTENSION RAIL in to find the other
holes that line up with the holes in the UPRIGHT. Turn a SCREW into these holes.
å
NOTE: The EXTENSION SLIDES will be used later for the LARGE DRAWER.
6
Push the lever and pull the SLIDE from the RAIL.
Open end
Page 8
Open end
5
www.sauder.com/service
23
3/8" PAN HEAD SCREW
(3 used in this step)
5
E
7
429257