Sauder worksense MASON PEAK Serie Instrucciones De Montaje página 11

Step 5 Step
å
Fasten the TIE PLATES (3G) to the remaining TOP MOLDING (H). Use two BLACK 9/16" LARGE HEAD SCREWS (1S).
å
NOTE: The TIE PLATES will overhang the edges of the MOLDING.
å
Fasten the TIE PLATES on the TOP MOLDING (H) to the RIGHT PEDESTAL and LEFT PEDESTAL. Use two BLACK 9/16"
LARGE HEAD SCREWS (1S).
å
NOTE: Be sure both ends of the TOP MOLDING (H) are the same distance from the front edges of the PEDESTALS.
BLACK 9/16" LARGE HEAD SCREW
(4 used in this step)
3G
LEFT PEDESTAL
www.sauder.com/commercial-office/service
1S
3G
H
The angled edge
should be toward the
inside of your unit.
H
Both ends of the MOLDING should
be the same distance from the
front edges of the PEDESTALS.
unit number
RIGHT PEDESTAL
Page 11