Sauder worksense MASON PEAK Serie Instrucciones De Montaje página 14

Step 8 Step
å
With your hands, separate the LOCK MECHANISM SETS (193M). Be careful of any sharp edges after
separating each set.
å
Fasten the LOCK MECHANISM SETS (193M) to the TOP (G) exactly as shown. Use four BLACK 15/16"
SHOULDER SCREWS (144S).
å
NOTE: Be sure the post on the bottom surface of the LOCK MECHANISM SET inserts into the hole in the TOP.
å
NOTE: The handle should face toward the back edge of the TOP.
å
NOTE: The SHOULDER SCREW will allow the LOCK MECHANISM to swivel.
BLACK 15/16" SHOULDER SCREW
(4 used in this step)
193M
Post
Page 14
144S
Handle
unit number
G
193M
Post
www.sauder.com/commercial-office/service
Handle