Sauder Whitaker Point Serie Instrucciones De Montaje página 15

Step 9
å
Fasten one SHORT EXTENSION RAIL (1) each to the RIGHT END (B) and RIGHT UPRIGHT (D). Use six 3/8" FLAT
HEAD SCREWS (30).
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner
cartridge of the EXTENSION RAIL in to find the other holes that lines up with the holes in the END and UPRIGHT. Turn
a SCREW into these holes.
å
NOTE: The EXTENSION SLIDES will be used later for the DRAWERS.
30
3/8" FLAT HEAD SCREW
(6 used in this step)
Open end
429369
1
Use these holes.
1
www.sauder.com/service
1
B
D
Open end
Page 15