Sauder Whitaker Point Serie Instrucciones De Montaje página 22

Step 16
å
Fasten one SHORT EXTENSION RAIL (1) to the LEFT EXTENSION BLOCK (EE). Use three 3/8" FLAT
HEAD SCREWS (30).
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner
cartridge of the EXTENSION RAIL in to find the other holes that lines up with the holes in the END and UPRIGHT. Turn
a SCREW into these holes.
å
NOTE: The EXTENSION SLIDES will be used later for the DRAWERS.
å
Repeat this step for the RIGHT EXTENSION BLOCK (FF).
Open end
Page 22
EE
C
1
www.sauder.com/service
1
Use these holes.
FF
D
30
3/8" FLAT HEAD SCREW
(6 used in this step)
429369