Publicidad
3. The switch
Make sure the switch trigger is returned to its original
position by pushing it.
4. The power source
You must use the tool in the power soure specified in
the nameplate. When you use the tool for 110V in
220V/230V, the speed of the motor will be increased
abnormally. Inresult, the Hammer drill bit and the tool
may be damaged.
When you use the tool for 110V in
220V/230V, the motor can be damaged
by a fire.
5. Mains outlet
When inserting the plug, if a sound is heard or if it is a
taken out easily, you must repair it. Please contact
nearby electric shop.
When you use the mains outlet as it is, it causes the
accident by overheating.
6. An explanation of any symbols or picto-
grams marked on the tool relevant to safe
use
Noise and Vibration Emissions
1. Noise and vibration
Noise emission values determined according to
EN 62841.
2. The operator to wear hearing protection
12
3. Vibration emission
Vibration total values(triaxial vector sum) determined
according to EN 62841.
4. The following information
• The declared vibration total value has been measured
in accordance with a standard test method given in EN
62841 and may be used for comparing one tool with
another.
• The declared vibration total value may also be used in a
preliminary assessment of exposure.
5. A warning
• The vibration emission during actual use of total value
depending on the ways in which the tool is used.
• Identify additional safety measures to protect the opera-
tor that are based on an estimation of exposure in the
actual conditions of use (taking account of all parts of
the operating cycle such as the times when the tool is
addition to the trigger time).
Specifications and List of Contents
1. Specifications
2. List of contents
Publicidad
