Dantherm HPP Serie Manual De Instalación página 17

Parameter checking and
setting.
Notes:
Setting the time and timers.
Notes>
Controller operations
Press the button for 10 seconds to enter the parameter checking interface, then press
the parameter settings menu. You can now adjust parameters value with the
Press to save and switch to other parameter settings.
a) Press the button for 10 seconds to enter parameter checking and adjusting status.
b) Press to switch to different parameter checking.
c) Press to enter into the parameter settings status, and change parameter values with
Press to save and switch to other parameter settings.
d) Under parameter checking status, press
e) You can check and adjust the set parameters during standby mode; you cannot adjust the parameters
when the unit is running.
Parameter settings will be invalid if the power fails within 10 seconds of making an adjustment.
Press the directly to enter timer settings. The clock icon
with the , press again to set Minute with
settings. If not required, press to enter into the next group of timer settings.
Three daily timers can be set but each timer needs to a set ON and OFF time.
Press directly to enter Timer Settings. The icon
Hour with , and press
If you need to cancel Timer Settings, please press
into the next group of timer settings. If you do not want to save data, please press
next group of timer settings.
to exit parameter checking status.
will flash, then press
, then press
will flash, then press
again to set Minute with
and "-- : --"will display. Press
to enter
and keys.
,
to set Hour
to save and complete
to set
.
to save and enter
to enter into the
17
EN
.