Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
Siting
Warning
Installation
requirements
Operation
Safety Precautions
•
Ensure that the heat pump on site is as ordered, i.e. model, electrical supply.
•
Inspect the unit for damage, in particular inspect the evaporator (finned side) to ensure
that it is undamaged. (Minor indentations in the fins do not affect performance). If severely
damaged, endorse the delivery note in the presence of the driver and send a recorded
delivery letter to the transport company giving details.
•
Protect the unit if installation is delayed.
•
Provide a firm level base capable of supporting the weight of the unit; spread the load if
mounted on a timber floor.
•
Ensure that water cannot collect under the unit, it is recommended that units are installed
on plinths 100mm above finished floor level. This also aids condensate drainage.
•
Please allow adequate clearance to service panels on the unit; recommended 500mm
minimum.
•
The HPPs are by design as quiet as is practical, however due consideration should be given
to siting the HPP in order to minimise the effect of noise coming from the HPP, for example
by positioning the HPP so that the inlet/outlets are parallel to occupied premises.
•
Ensure loose debris such as leaves, grass cuttings, etc. will not block air inlet grilles.
•
Consider protection from extreme weather conditions if installed externally near to sea
spray etc., i.e. lean-to-cover or open walled building.
•
Use the anti-vibration feet provided, these help to reduce the noise from the HPP and
also help to prevent corrosion to the base of the HPP. The use of stainless steel fixings is
recommended.
•
Always ground the unit
•
Securely connect the electrical power
•
Do not install the product in a high place with the risk of it falling down.
Incorporate the following when installing the electrical connections:
•
DC external supply should be protected with an external circuit breaker at 35 Amps
•
Label disconnected devices, stating rated voltage and rated current.
•
It is imperative to secure and install all connections to prevent any damage to equipment
and/or humans.
Secure all cables with cable ties or appropriate cable fasteners.
WARNING
•
Make sure all power is disconnected prior to installation, maintenance or service.
•
Do not allow water to run into electrical parts
•
Do not place obstacles around the air flow inlet or outlet
EN
5
Publicidad
