Dantherm HPP Serie Manual De Instalación página 3

Introduction!
Usage of the
HPP Heat Pump
Important
HEALTH AND SAFETY
WARNING
Product description
This section describes the overall product, and its functionality
The Dantherm HPP range of air to water heat pumps is designed for swimming pool and Spa
heating and consists of 4 sizes. HPP heat pumps are designed to heat pool water and spas
within a water temperature range of +15°C to 40°C.
Every model within the HPP range can operate in outside temperatures from +3°C to +35°C.
The water heat exchanger is a full flow type, manufactured from titanium tube, which is a highly
corrosion resistant material.
The heat pumps are suitable for use in fresh water and salt water pools.
HPP 6, 8 and 12 heat pumps are fitted with rotary compressors.
The HPP 15 and 20 heat pumps are fitted with a scroll compressor.
Both types of compressor are for known long service life, efficiency and quiet running.
A 3 minute compressor start delay timer is incorporated for compressor protection.
With these features the heat pump is designed to have a long, trouble free life.
All HPP units have integral safety devices to protect the heat pump from internal and external
faults.
The touch screen user interface displays the operating mode. The digital thermostat within the
user interface controls the water temperature.
Dantherm A/S recommends that the heat pump should be powered continuously!
This appliance can be used by children from eight years and above and persons with reduced
physical, sensory or mental capabilities or lack of experience and knowledge if they have been
given supervision or instruction concerning the use of the appliance in a safe way and
understand the hazards involved. Children should not play with the appliance. Cleaning and
maintenance shall not be made by children without supervision.
Disconnect from the mains supply and wait three minutes before removing panels and
commencing work on this machine.
EN
3