Publicidad
Idiomas disponibles
Idiomas disponibles
Before each operation, disconnect the appliance from
the electrical power supply. To ensure that the appli-
ance lasts a long time, it must be thoroughly cleaned fre-
quently, keeping in mind that:
·
Do not use steam equipment to clean the appliance.
•
The enamelled parts and the self-cleaning panels
should be washed with warm water, without using any
abrasive powders or corrosive substances which could
ruin them;
•
The inside of the oven should be cleaned fairly often
while it is still warm, using warm water and detergent
followed by careful rinsing and drying;
•
The flame spreaders should be washed frequently with
hot water and detergent, taking care to eliminate any
buildup;
•
On cookers equipped with automatic lighting, the ter-
minal part of the electronic instant lighting devices
should be cleaned frequently and the gas outlet holes
on the flame spreaders should be checked to make
sure they are free of any obstructions;
•
Stainless steel may become marked if it comes into
contact with very hard water or harsh detergents (con-
taining phosphorous) for long periods of time. After
cleaning, it is advisable to rinse thoroughly and dry. It
is also recommended that drops of water be dried.
N.B.: Avoid closing the cover while the gas burners
are still warm.Remove any liquid from the lid before
opening it.
Important: Periodically check the wear of the gas hose
and substitute it if there are any defects; we recommend
changing it every year.
Routine Maintenance and Cleaning
Replacing the Oven Lamp
•
Disconnect
the cooker from the power supply by means
of the omnipolar switch used to connect the cooker
the electrical mains; or disconnect the plug if it is ac-
cessible.
•
Remove the glass cover of the lamp-holder.
•
Remove the lamp and replace it with a lamp resistant
to high temperatures (300°C) with the following speci-
fications:
- Voltage: 230V
- Wattage: 25W
- Socket: E14
•
Replace the glass cover and connect the oven to the
mains.
Gas tap maintenance
The taps may jam in time or they may become difficult to
turn. If so, the tap itself must be replaced.
N.B.: This operation must be performed by a technician
authorised by the manufacturer.
22
to
Publicidad
