Introduction - Nussbaum ATT COMBI LIFT CL 4.40 S Instrucciones De Servicio

ENGLISH
1

Introduction

Nussbaum products are a result of many years of
experience. A high quality standard and superior
concept guarantees you reliability, long lifetimes
and economical operation. To prevent unneces-
sary damage and hazards, read this operating
manual carefully and always comply with its con-
tents.
! Any other use, or use beyond purpose is consi-
dered improper.
! Otto Nußbaum GmbH & Co.KG is not liable for
any resulting damage. The operating compa-
ny alone carries the risk.
Proper use also includes:
• Adherence to all instructions in this operating
manual and
• Compliance with inspection and maintenance
work and the inspections stipulated.
• The operating manual is to be followed by all
personnel working on the system. This is notably
with regards to Section 3 "Safety conditions"
• In addition to safety information from the opera-
ting manual, comply with rules and regulations
at the location of use.
• Proper system handling
Operating company obligations:
The operating company is obliged to only permit
personnel to work on the system who
• understand the principle regulations about work
safety and accident prevention and who have
been trained in working with the system.
• have read the safety section and warning infor-
mation in this operating manual, have under-
stood it and confirmed learning with a signature.
Hazards in working with the system:
Nussbaum products have been designed and
built to state-of-the-art and to recognized safety
standards. However, improper use may lead to
hazards to life and limb of the user or result in pro-
perty damage.
The system may only be operated
• for proper intended use
• if it is technically in perfect condition
Organizational measures
• The operating manual is always to be kept ready
at the location of use of the system.
• Supplemental to the operating manual, refer to
and comply with generally valid legal and other
binding regulations for accident prevention and
for environmental protection.
• Check occasionally that personnel have an
awareness of hazards and safe work in compli-
ance with the operating manual!
• Use personal protective equipment as needed
or required by regulations.
• All safety and hazard information on the system
is to be kept in a legible condition!
• Replacement parts must meet technical specifi-
cations of the manufacturer. This is only guaran-
teed for original parts.
• Deadlines pre-set or given in the operating ma-
nual for repeating tests / inspections must be fol-
lowed.
Maintenance work, error removal
• Comply with pre-determined setting, mainte-
nance and inspection work and intervals in the
operating manual, including details for exchan-
ging parts / part fittings! These activities may only
be done by specialists who have participated in
a special factory training.
Guarantee and liability
• In principle, our "General sales and supply con-
ditions" apply.
Guarantee and liability claims for personal and
property damage are excluded if due to one or
more of the following causes:
• Improper use of the system.
• Improper assembly, commissioning, operation
and maintenance of the system.
• Operating the system with defective safety de-
vices or improperly attached or non-functional
safety and protection devices.
Original