General Information; Set Up And Test The System; Hazard Information; Safety Regulations - Nussbaum ATT COMBI LIFT CL 4.40 S Instrucciones De Servicio

• Non-compliance with information in the opera-
ting manual in terms of transport, storage, as-
sembly, commissioning, operation, maintenance
and fitting of the system.
• Independent construction changes to the sys-
tem.
• Independent changes to the system (e.g. drive
ratios: power, rotation speed, etc.)
• Improperly done repairs.
• catastrophic cases due to foreign influences or
force majeure.
2

General information

Technical documentation contains important in-
formation for safe operation and for retaining
functional safety of the system.
• To verify system set up, the set up protocol form is
to be signed and sent to the manufacturer.
• Forms are available in this inspection book for
use in verifying single, regular and extraordina-
ry safety checks. Use the forms to document in-
spections and leave the completed forms in the
inspection book.
• The system master forms must record changes to
the construction and changes to set up location.
2.1

Set up and test the system.

Safety relevant work on the system and safety in-
spections may only be done by personnel specifi-
cally trained to carry it out. They are designated
in general and in this documentation as technical
experts and specialists.
• Technical experts are people (freelance expert
engineers, TÜV specialists) that may inspect and
assess due to their education and experience
with lift systems. They are knowledgeable in the
appropriate work safety and accident preventi-
on regulations.
• Specialists (competent people) are people who
have sufficient knowledge and experience with
lift systems and have participated in a special
factory training by the system manufacturer.
46 COMBI LIFT 4.40 S-S A-S PLUS-S PLUS AMS - HYMAX II 4000 S-S A-S PLUS-S PLUS AMS
2.2

Hazard information

To become aware of the hazardous points and
important information, the following three symbols
are used with the descriptive meaning. Pay parti-
cular attention to text positions that are labeled by
these symbols.
i Note! Labels information about a key function
or points to an important remark!
! Caution! identifies a warning of possible system
damage or other operating company property
damage if the highlighted process is not done
properly!
Danger! identifies a danger to life
and limb, if the highlighted process is
not done properly there is a mortal dan-
ger!
3

Safety regulations

When working with systems comply with legal ac-
cident prevention regulations according to BGG
945: inspection of lifts; BGR 500 operation of sys-
tems; VBG 14.
Particular attention is drawn to compliance with the
following regulations:
• The max. load carrying capacity for lifts may not
be exceeded.
For this, see details on the model plate.
• When operating the system, follow safety regula-
tions and operating instructions in the operating
manual.
• Only personnel aged 18 or over may operate
systems independently, they must be trained in
system operation and have their work verified
by the company. They must be explicitly tasked
with operating the system (excerpt from BGR
500), see transfer protocol.
• The lift must be completely lowered before the
vehicle is driven on, and it may only be done in
the intended direction.
• Before positioning and lifting vehicles with low
floor clearance or custom equipment check
whether damage could occur.
25.09.2015 20110006 OPI