Silvercrest SSH 600 A1 Instrucciones De Uso página 86

Handling and operation
Switching the appliance on and off
♦ Plug the appliance into a suitable, easily accessible mains socket.
The power plug must be fully inserted into the mains socket.
Switch on the appliance by pressing the On/Off switch q. The
♦
operating LED 5 lights up red to show that the appliance is in
standby mode.
♦ Press the button 1 to turn on the fan heater. The factory
preset temperature
♦ Press the
standby mode. The display 3 goes out, while the operating
LED 5 remains lit up red. The fan continues to run for approx.
60 seconds to cool down the appliance.
Switch off the appliance by pressing the On/Off switch q. The
♦
operating LED 5 goes out, the appliance is disconnected from
the power supply. Now unplug the appliance from the mains
socket.
WARNING! THE FAN HEATER GETS VERY HOT
DURING USE. Allow it to cool down before you disconnect
it from the mains socket. Touch the heater only by the grips w
provided.
SSH 600 B2
(25° Celsius) appears on the display 3.
button 1 again to switch the fan heater back into
GB │ MT │
83
■