NEO TOOLS 90-112 Manual De Usuario página 7

• If the power supply cable is damaged, it must be replaced by the
manufacturer, its representative, service or a qualified person in
order to avoid danger.
• Do not connect other devices to the same mains socket to which the
device is connected.
• The appliance should not be left unattended. Keep children and pets
away from the appliance.
• Do not place the unit on unstable, moving surfaces or where the unit
can be knocked over.
• If the appliance is not used for a long time, unplug it from the power
supply. Do not leave the appliance switched on unattended. When
disconnecting the appliance from the mains, pull out the plug, never
pull on the power cord.
• Keep the unit away from curtains, curtains or places where the air
inlet is easily blocked.
• To prevent possible electric shock, never operate the appliance with
wet hands or when there is water on the power cord.
• Do not dispose of electrical appliances with unsorted municipal
waste, use separate collection points. Contact your local authorities
for information on available collection systems. If electrical
appliances are disposed of in landfill sites, hazardous substances
can seep into the groundwater and enter the food chain, damaging
your health.
• This equipment is not intended for use by persons (including
children) with reduced physical or mental capabilities or without
experience unless supervision or instruction is provided regarding
the safe use of the equipment so that the associated risks are
understood.
• Children should be supervised to ensure that they do not play with
the appliance.
• Do not modify or repair the appliance yourself. To do so, send it to
a service centre or qualified electrician (during the post-warranty
period).
PICTOGRAMS AND WARNINGS
Read the operating instructions, observe the warnings and safety
conditions contained therein!
The device may need to be fitted
Do not touch the hot surface
Do not cover
Disconnect from power supply before repair or maintenance
For indoor use
Protect from moisture
Keep out of reach of children
Do not dispose of with household waste
Recyclable
DESCRIPTION OF THE GRAPHIC ELEMENTS
The following numbering refers to the components of the device
shown on the graphic pages of this manual.
Designation
Heater
1
Heater
2
Heater switches
3
Transport handle
4
Ventilation openings
5
Legs
6
* There may be differences between the graphic and the actual product
PURPOSE
This product is intended for home and office use only and not for industrial
or other commercial use. Use only with a power supply cord that is
undamaged and in good condition, which meets the applicable standards
and regulations. The heater must be powered from the mains whose
parameters are specified in the rating table. Do not connect other
additional appliances on the same circuit as the heater in operation.
OPERATION OF THE DEVICE
Description
The unit is equipped with a two-stage heating system, activated by two
independent switches Figure A3 and by heaters Figure A1 and A2.
To start the heater, press the button or buttons fig. B switch to the I/ON
position fig. B1.
To switch the heater off, press the button or buttons Fig. B of the switch to
the 0/OFF position Fig. B3.
The buttons activating the heaters and the heaters themselves operate
independently of each other and can be activated in any order.
SECURITY
The radiator is fitted with a safety mechanism that disconnects the power
if the radiator is tilted or overturned. The control button for this mechanism
is located on the underside of the heater fig. B4.
ATTENTION It is strongly recommended not to use the button while the
unit is in operation.
OPERATION OF THE HEATER:
Always operate the heater in an upright position, following all instructions
and recommendations listed in this manual
HEATER LOCATION:
Place the heater in the coldest part of the room.
HEATER CONNECTION:
Plug the heater directly into a wall socket. Make sure that the plug fits
tightly into the socket. A loose connection can cause overheating and
damage to the plug.
NOTE: To prevent overloading the circuit, do not connect the heater to a
circuit that serves other electrical needs.
MAINTENANCE AND STORAGE
• Unplug the appliance from the power supply and allow it to cool
down before cleaning. The housing of the appliance gets dirty easily,
so wipe it frequently with a soft sponge. Wipe any soiled component
with a sponge soaked in warm water with mild detergent. Then wipe
the washed item with a dry cloth. Take care that water does not get
inside the unit. To protect the housing, do not use solvents or strong
detergents for cleaning.
• Care should be taken to prevent dust from settling on the heater
protection grille. For this purpose, the grille should be periodically
cleaned of dust and other elements.
• Clean the power cord and plug, then dry and pack in a plastic bag.
• Store the unit in a dry ventilated room away from children.
Quartz infrared heater 90-112
Parameter
Supply voltage
Supply frequency
Heating power (1st stage / 2nd stage)
Dimensions
Protection class
IP degree of protection
Weight (without accessories)
Year of production
ENVIRONMENTAL PROTECTION
Electrically-powered products should not be disposed of with household
waste, but should be taken to the appropriate facilities for disposal.
Contact your product dealer or local authority for information on disposal.
Waste electrical and electronic equipment contains environmentally inert
substances. Equipment that is not recycled poses a potential risk to the
environment and human health.
"Grupa Topex Spółka z ograniczoną odpowiedzialnością" Spółka komandytowa with its
registered office in Warsaw, ul. Pograniczna 2/4 (hereinafter: "Grupa Topex") informs that
all copyrights to the content of this manual (hereinafter: "Manual"), including, among
others. Its text, photographs, diagrams, drawings, as well as its composition, belong
exclusively to Grupa Topex and are subject to legal protection under the Act of 4 February
1994 on Copyright and Related Rights (ie Journal of Laws 2006 No. 90 Poz. 631, as
amended). Copying, processing, publishing, modification for commercial purposes of the
entire Manual and its individual elements, without the consent of Grupa Topex expressed
in writing, is strictly prohibited and may result in civil and criminal liability.
EU declaration of conformity
Manufacturer: Grupa Topex Sp. z o.o. Sp.k., Pograniczna 2/4 02-285
Warszawa
Product: Quartz infrared heater
Model: 90-112
Trade name: NEO TOOLS
Serial number: 00001 ÷ 99999
This declaration of conformity is issued under the sole responsibility of
the manufacturer.
7
Value
230V AC
50 Hz
400W / 800W
310x150x370
I
IPX0
0.96 kg
2023