Please note that the following maintenance intervals apply for normal
operating conditions only. If your daily work requires longer than
normal or harsh cutting conditions are present, then the suggested
intervals should be shortened accordingly.
Complete Machine
Controls (STOP button, Choke Lever,
Throttle Trigger, Trigger interlock)
Fuel Tank
Fuel Filter and tube
Cutting Attachments
Bevel Gear
Clutch Drum
Cutting Attachments Guard
All Accessible Screws and Nuts (Not
Adjusting Screws)
Air Filter
Cylinder Fins
Starter System Vents
Starter Rope
Carburetor
Spark Plug
Vibration Mounts
Cutting Attachments nuts and
screws
MAINTENANCE
Maintenance Chart
Inspect (Leaks, Cracks, and Wear)
Clean after finishing daily work
Check Operation
Inspect (Leaks, Cracks, and Wear)
Clean
Inspect
Clean, Replace Filter Element
Inspect (Damage, Sharpness, and
Wear)
Check Tension
Sharpen
Inspect (Damage, Wear and
Grease Level)
Inspect (Damage, Wear and
Grease Level)
Replace
Inspect (Damage, and Wear)
Replace
Inspect
Retighten
Clean
Replace
Clean
Clean after finishing daily work
Inspect (Damage, and Wear)
Replace
Check Idle (Cutting Attachments
must not
rotate at idle)
Check Electrode Gap
Replace
Inspect (Damage, and Wear)
Replace by Dealer
Check that the locking nut of the
cutting equipment is tighten
correctly
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
en
x
x
x
x
25