Hitecsa 117 Manual De Instalación, Uso Y Mantenimiento página 31

II.6.5.2 Integrative thermal source (KRIT accessory)
An integrative thermal source is an electric resistance that runs together with the EQUHI PF heat pump in winter mode. By means of the unit's control, it
is possible to control start-up and switch-off according to the different variables: outdoor air temperature, delay in reaching the set-point set due to a high
thermal load.
Resistance is always activated during the defrost cycle and when DHW production is requested.
When there is a 3-way valve for KVDEV DHW production, the electrical resistance must be placed upstream of the valve, as illustrated in the figure.
It is always recommended to accurately check the electrical power available when integrative electrical resistances are installed.
System configuration for P0lPI0lP1 set up
3
System configuration for ASP0lASPI0lASP1 set up
3
IOM_EQUI PF-EQUHI PF_117a128_207983_200101_ES-EN-FR-DE-IT
2
4
7
8
5
4
7
8
33
1. Chiller
2. Inertial storage tank
3. Hydraulic circuit breaker
4. Electric heater
5. 3-way valve (optional)
6. Domestic
7. Technical water storage tank
8. Pump
6
1.
2.
3.
1
4.
5.
6.
2
7.
8.
6
Chiller
Inertial storage tank
Hydraulic circuit breaker
Electric heater
3-way valve (optional)
Domestic
Technical water storage tank
Pump