Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Examine the work area. Remove all stones, sticks,
wire, bones, and other debris that can ricochet
because of the rotating impeller.
If it is possible, clear the snow in the direction of the
wind.
8.3
ADJUST THE SPEED
1.
Push the speed switch to the desired operating
speed. Push the speed switch to position 1 for
high speed or position 2 for low speed.
8.4
STOP THE MACHINE
1.
Release the trigger to stop the machine.
8.5
OPERATE THE MACHINE
1.
Start the machine.
2.
Push the machine forward until it rides on the
scraper.
WARNING
NOTE
English
The forward speed is dependent on the depth and
weight of the snow.
9
MAINTENANCE
Remove the battery pack from the machine before
maintenance.
Wear correct clothing, gloves and safety glasses
before maintenance.
Use only approved replacement parts.
Do not let brake fluids, gasoline, petroleum-based
materials touch the plastic parts. Chemicals can
cause damage to the plastic, and make the plastic
unserviceable.
Do not use strong solvents or detergents on the
plastic housing or components.
9.1
GENERAL MAINTENANCE
• Before each use, examine the machine for
damaged, missing, or loose parts such as screws,
nuts, bolts and caps.
• Tighten all the fasteners and caps correctly.
• Clean the remaining snow on the machine with a
brush.
9.2
REPLACE THE SCRAPER
1.
Put the machine on a flat, level surface.
2.
Face up the impeller.
3.
Remove the 4 screws (12) below the impeller that
attach the scraper to machine.
10
NOTE
WARNING
WARNING
CAUTION
CAUTION
CAUTION
Publicidad
