Publicidad
Idiomas disponibles
Idiomas disponibles
2.3
OPERATION
• Do not put hands or feet near or under rotating
parts. Keep clear of the discharge opening at all
times.
• Exercise extreme caution when operating on or
crossing gravel drives, walks, or roads. Stay alert
for hidden hazards or traffic.
• After striking a foreign object, turn the machine off
and remove the battery pack, and then inspect it for
damage. Repair any damage before restarting and
using the machine.
• If the power tool should start to vibrate abnormally,
stop the machine and check immediately for the
cause. Vibration is generally a warning of trouble.
• Stop the machine whenever you leave the operating
position, before unclogging the collector/impeller
housing or discharge guide, and when making any
repairs, adjustments, or inspections.
• When cleaning, repairing, or inspecting, make
certain the collector/impeller and all moving parts
have stopped.
• Exercise extreme caution when operating on slopes.
• Never operate the snow thrower without proper
guards, keep other safety protective devices in
place and working.
• Never direct the discharge toward people or areas
where property damage can occur. Keep children
and others away.
• Don't Overreach – Keep proper footing and balance
at all times.
• Do not overload the machine capacity by attempting
to clear snow at too fast a rate.
• Don't Force Snow Thrower – It will perform better
and safer at the rate for which it was designed.
• Never operate the power tool at high transport
speeds on slippery surfaces. Use care when
reversing.
• Never direct discharge at bystanders or allow
anyone in front of the power tool.
• Disengage power to the collector/impeller when the
power tool is transported or not in use.
• Use only attachments and accessories approved
by the manufacturer of the snow thrower (such as
wheel weights, counterweights, or cabs).
• Never operate the power tool without good visibility
or light. Always be sure of your footing, and keep a
firm hold on the handles.
• Walk, never run.
• Clearing a Clogged Discharge Chute.
• Hand contact with the rotating impeller inside the
discharge chute is the most common cause of injury
associated with snow throwers. Never use your
hand to clean out the discharge chute. To clear the
chute:
English
1.
SHUT THE ENGINE（Motor） OFF!
2.
Wait 10 seconds to be sure the impeller blades
have stopped rotating.
3.
Always use a clean-out tool, not your hands.
• If the snow thrower strikes a foreign object follow
these steps:
1.
Stop snow thrower. Release the switch.
2.
Remove the battery pack.
3.
Inspect for damage.
4.
Repair any damage before restarting and
operating the snow thrower.
2.4
MAINTENANCE
• Check shear bolts; engine-mounted bolt, etc., at
frequent intervals for proper tightness to be sure the
power tool is in safe working condition.
• Always refer to owner's guide instructions for
important details if the power tool is to be stored
for an extended period.
• Store Idle Snow throwers Indoors – When not in
use, snow throwers should be stored indoors in a
dry, locked-up place – out of reach of children.
• Run the power tool a few minutes after throwing
snow to prevent freeze-up of the collector/impeller.
• Do not use a battery pack or appliance that
is damaged or modified. Damaged or modified
batteries may exhibit unpredictable behavior
resulting in fire，explosion or risk of injury.
• Do not expose a battery pack or appliance to fire
or excessive emperature space. Exposure to fire
or temperature above 265°F (130°C) may cause
explosion.
• Follow all charging instructions and do not charge
the battery pack or appliance outside of the
temperature range specified in the instructions.
Charging improperly or at temperatures outside of
the specified range may damage the battery and
increase the risk of fire.
• Have servicing performed by a qualified repair
person using only identical replacement parts.
This will ensure that the safety of the product is
maintained.
• Do not modify or attempt to repair the appliance or
the battery pack (as applicable) except as indicated
in the instructions for use and care.
• Maintain Snow Thrower with care - follow
instructions for changing accessories.
5
EN
Publicidad
