Publicidad
Idiomas disponibles
Idiomas disponibles
12. Replace and tighten the remaining screws on the
right side cover.
10
TRANSPORTATION AND STORAGE
• Clean the machine before storage.
• Make sure the engine is not hot when you stow the
machine.
• Make sure that the machine does not have loose or
damaged parts. If it is necessary, do these steps/
instructions:
• Replace the damaged parts.
• Tighten the bolts.
• Speak to a person of an approved service center.
• Stow the machine in a locked, dry area.
• Make sure that children cannot come near the
machine.
• When you move the machine, hold it by the top
handle and auxiliary handle.
English
11
TROUBLESHOOTING
Problem
The handle is
not in position.
The machine
does not start.
The engine is
on, but the im-
peller does not
turn.
A thin layer of
snow stays be-
hind.
* If you cannot find the solution to these problems, call
1-855-345-3934.
13
Possible
Solution
cause
The bolts are
Adjust the
not engaged
height of the
correctly.
handle and
make sure that
the knobs and
bolts are
aligned correct-
ly.
The battery is
Charge the bat-
not charged.
tery by following
the procedures
in the battery
and charger
manual.
The switch is
Have the switch
defective.
replaced by an
authorized serv-
ice center.
Battery is too
Remove battery
cold.
from the snow
shovel. Place
battery on
charger and al-
low to charge
for 10 minutes
or until the
changing light
turns green. Re-
move from
charger and in-
stall in snow
shovel for use.
Battery may re-
Call toll free
quire service or
helpline, at
replacement.
1-855-345-3934
or replace bat-
tery.
The belt is dam-
Replace the
aged.
belt.
The scraper is
Replace the
damaged.
scraper.
EN
Publicidad
