Publicidad
Idiomas disponibles
Idiomas disponibles
EN
4.
Remove the machine from the box.
5.
Discard the box and packing material in
compliance with local regulations.
7.2
ATTACH THE SHAFT
If the button does not release fully in the location
hole, the shafts are not locked into position. Turn
from side to side until the button is locked into
position.
1.
Loosen the lock knob on the coupler (11).
2.
Align the release button (9) with the location hole
(10) and move the two shafts together.
3.
Turn the upper shaft until the release button (9)
locks into the location hole (10).
4.
Tighten the lock knob.
7.3
ATTACH THE AUXILIARY HANDLE
1.
Push the auxiliary handle onto the shaft.
NOTE
9
10
11
English
2.
Set the auxiliary handle in the comfortable
position.
3.
Tighten the auxiliary handle with the knob.
7.4
INSTALL THE BATTERY PACK
• If the battery pack or charger is damaged, replace
the battery pack or the charger.
• Stop the machine and wait until the engine stops
before you install or remove the battery pack.
• Read, know, and do the instructions in the battery
and charger manual.
1.
Align the lift ribs on the battery pack with the
grooves in the battery compartment.
2.
Push the battery pack into the battery
compartment until the battery pack locks into
place.
8
WARNING
Publicidad
