Changing Batteries; Internal Display - Nikon PROSTAFF 3 Manual De Instrucciones

Changing batteries

• Type of battery: 3V CR2 lithium battery
En
Fr • Battery condition indicators
: Battery has enough power for use.
Es
: Battery is getting low.
Pt
flashing: Battery is low and battery should be replaced.
disappears: Battery is exhausted and should be replaced.
* Flashing battery mark on the LCD warns that the battery should be replaced.
1 Open the battery chamber cover
Using the ball of the thumb, etc. in the recessed part of the battery chamber cover, rotate the cover
following the Open/Close arrow indicator.
It may not open easily due to its rubber packing for water resistance.
2 Replace the old battery with a new one
Install new battery with the [+] and [-] correctly positioned following the "Battery installation" indication
seal in the battery chamber. (Insert battery positioning the [+] pole towards the inside of the chamber.)
[The PROSTAFF 3 will not operate if the battery is installed incorrectly.]
3 Close the battery chamber cover
Align the Open/Close indicator with the white dot and insert the battery chamber cover. Using the ball
of the thumb, etc., turn the cover in the opposite direction to the arrow indicator. It may not close easily
due to the rubber packing for water resistance, but continue to turn it all the way until it stops. Confirm
that the cover is securely closed.
• Battery life
Continuous operation: Approx. 10,000 times (at 20°C)
Target focusing, measurement, and automatic power off are included in a single cycle. This figure may differ
according to temperature, and other factors such as target shape, colour, etc.
* The PROSTAFF 3 comes with a 3V CR2 lithium battery. However, due to natural electric discharge, the life of the battery will
likely be shorter than that noted above.
* Replace battery if the PROSTAFF 3 is ever submerged in water or if water enters in the battery chamber.
10

Internal display

1. 『 』 - Target mark/Laser irradiation
『 』 - Aim at the target. Position the target at the center of the reticle.
『 』 - Appears while the laser is being used for a measurement.
(Remains present during single measurement and continuous
measurement.)
Warning: Do not look into the objective lenses when this mark is shown.
2． 『 』: Distance/measurement status display
Digitally indicates measured distance in meters/yards. Also indicates measuring
status such as "Measurement in progress", "Measurement unsuccessful" or "Unable
to measure."
<Examples of measurement results>
(Distance)
Display of results: ( ≧ 100m/yards) e.g. 234 meters = 『
Display of results: ( ＜ 100m/yards) e.g. 76.5 yards = 『
『 』 - Now measuring
『 』 - Failure to measure or unable to measure distance
3. 『 』 Display Units
『 』Indicates distance being measured in meters.
『 』Indicates distance being measured in yards.
4. 『 』- Indicates battery condition. (See "Changing Batteries")
* Although the LCD was produced using the most advanced technology, it is impossible to eliminate dust
completely. When using this product, the LCD is magnified by high magnification of the eyepiece lens and
dust may appear as a defect. It will not, however, affect measurement accuracy.
En
Fr
Es
Pt
』
』
11