Publicidad
Idiomas disponibles
Idiomas disponibles
EN
ALARM INSTRUCTIONS
If the terminal and GND are short-circuited, the alarm is triggered, the indoor unit's
speaker sounds and continues for 120s; during this time, click the hang-up button to
stop the alarm and enter standby mode.
For models with SD card, activate recording or snapshot at the same time (depending
on system settings). The recording time is 120s; during this period, click the hang-up
button to stop the alarm and enter standby mode.
Connection diagram:
Two normally closed (NC) or normally open (NO) alarm inputs can be connected.
The ALM terminal of the alarm detector is connected in parallel to the ALM
terminal (the alarm detector must be powered by an external power supply).
The ground terminal of the alarm detector is connected in parallel to the GND
terminal of the camera. For NO alarm inputs, when GND and ALM are in a
connected state, the alarm is activated. For NC alarm inputs, when GND and
ALM are in the disconnected state, the alarm is activated. Applies to any alarm
sensor.
EN
TECHNICAL FEATURES
Product type
Display
Resolution
Standard
Calling mode
Power consumption
Power supply
Work temperature
Installation
SD card max capacity
Video input
Motion detection
System
Function
Advantages
AHDo720P/960P/ CVBS video input
7" TFT LCD/10.1"TFT LCD
7"(1024*600),10.1"(1024*600)
PAL/NTSC
Two-way intercom
Max. 500mA/600mA
External power DC; Built-in power AC100-240V
0~+50℃
Surface mounting
32GB; class 10 TF(Micro SD) Note: Max. class 10
CVBS/AHD2.0
Yes
Support 6 indoor monitors + 2 external units + 2 cameras
Unlock/monitoring/internal call/transfer call/recording
Photo frame/Mp3, Mp4 player/clock, voice message/music
47
Publicidad
