Uline H-10371 Instrucciones De Montaje página 5

IMPORTANT! Turn cam lock (R) 1/4 to the right to
lock. Ensure arrow is pointing toward edge of
panel before inserting into panel's hole.
IMPORTANT: Function of Cam Lock
Ensure the arrow is pointing toward edge of
panel before inserting into the panel's hole.
IMPORTANT! Cam lock pins (Q) must be
tightened once inserted into panel. To tighten,
grasp lower part of cam lock pin and tighten
using a Phillips screwdriver.
TIGHTENING OF CAM LOCK PINS
NOTE: Cam lock covers (U) can be applied
once cam locks are tightened for a finished
look.
5. Install two cam lock pins (Q) into back panel (10).
Insert two cam locks (R) into corresponding holes in
bottom panel (9). Fit bottom panel and back panel
together and tighten cam locks. (See Figure 11)
Figure 11
6. Install five cam lock pins (Q) and four dowels (S)
on each side panel (7 and 8). Insert cam locks (R)
into corresponding holes in bottom panel (9), back
panel (10) and skirt panel (11). Tighten cam locks.
(See Figure 12)
PAGE 5 OF 23
ASSEMBLY CONTINUED
1/4 Right Turn
for Locking
Hold when
tightening
9
10
9
R
Q
10
7. Insert M6 x 18 mm floor glides (L) into the bottom
edge of side panels (7 and 8). Glides can be
adjusted for uneven floors. (See Figure 12)
Figure 12
L
R
S
8
8. With second person, place return desktop (6)
upside down with holes facing up. Install 12 cam
lock pins (Q) into return desktop. (See Figure 13)
Figure 13
6
9. With second person, turn assembled bookcase
upright and place next to low lateral file cabinet (13).
Insert eight dowels (S) and 12 cam locks (R) into top
edges of bookcase and lateral file cabinet.
(See Figure 14)
NOTE: If assembling a left-handed
configuration, place bookshelf on the right
side of the low lateral file cabinet.
Figure 14
S
R
7
7
9
9
Q
8
Q
1122 IH-10371