Teka JZC 63312 A Manual De Usuario página 52

Every time the power level of a hotplate is
changed, the power limiter will calculate the total
power the hob is generating. If you have reached
the total power limit, the touch control will not allow
you to increase the power level of that hotplate.
The hob will beep and the power indicator (3) will
blink at the level that cannot be exceeded. If you
wish to exceed that value, you must lower the
power of the other hotplates. Sometimes it will not
be enough to lower another by a single level as
this depends on the power of each hotplate and
the level it is set at. It is possible that to raise the
level of a large hotplate that of several smaller
ones must be turned down.
If you use the quick switch-on at maximum power
function and the said value is above the value set
by the limit, the hotplate will be set to the
maximum possible level. The hob will beep and
the said power value will blink twice on the
indicator (3).
If due to an error one or several heating zones do not
switch off, the appliance will be automatically
disconnected after a set amount of time ( ).