Publicidad
Idiomas disponibles
Idiomas disponibles
GB
MT
40 mm - Position 4
50 mm - Position 5
60 mm - Position 6
70 mm - Position 7
The correct height is around 25 – 40 mm
for a decorative lawn and around 30 –
60 mm for a used lawn.
A higher cut height should be se-
lected for the fi rst cut of the season.
Observe the noise protection and
local regulations.
Switching On and Off
G
1. Insert the power cable plug into the
socket (13) on the curved handle (1).
2. Make a loop in the end of the power
cable (11) and suspend this in the
cable strain relief (12) to release the
strain.
3. Connect the equipment to the power
supply.
4. Before switching on, ensure that the
equipment is not in contact with any
objects.
5. To switch on, press the start button (15)
and one of the release buttons (14)
on the U-shaped handle (1). Keep one
of the release buttons (14) constantly
pressed.
6. To switch off, let the release button (14)
go.
After switching off the equ-
ipment, the blade continues
to turn for several seconds.
Do not touch the moving bla-
de. There is a risk of injury.
32
Working with the
Lawnmower
Regular mowing encourages increased foli-
ation of the grass and kills off weeds at the
same time. Therefore, not only does each
mowing increase the density of the lawn, it
also produces an evenly resilient lawn.
The fi rst cut is to be made in around April,
at a growth height of 70 – 80 mm. In the
main vegetation period, the lawn is to be
mowed at least once a week.
•
Start mowing near the socket and work
away from the socket.
•
Always keep the extension cable be-
hind you and when you turn, move it to
the side that has already been mowed.
•
Run the equipment at a walking pace,
in tracks that are as even as possible.
For gap-free mowing, the tracks should
always overlap by a few centimetres.
•
Adjust the cut height so the equipment
is not overloaded. Otherwise, the mo-
tor may be damaged.
•
On slopes, always work across the
slope. Take particular care when going
backwards and pulling the equipment.
•
Clean the equipment after each use, as
described in the chapter on "Cleaning,
Maintenance and Storage".
Switch off the equipment after
work and in order to transport it,
disconnect the plug and wait until
the blade stops. There is a risk of
injury.
Cleaning, Maintenance
and Storage
Have work that is not de-
scribed in these instructions
carried out by a customer
Publicidad
