Infiniton PAC-S10 Manual De Usuario página 39

Cooling
Mode
· Under cooling mode, cooling indicator will light on.
· Temperature Setting is from 16℃ to 30℃.
· Press Fan Speed Button to choose from low/ high fan speed.
Fan Mode
· Under Fan mode, indicator will be on.
· Press Fan Speed Button to choose from low/ high fan speed.
· Temperature cannot be set under this mode.
Dry Mode
· Dry indicator will be on under this mode.
· Remove water plug (see right), insert one end of pipe to
drainage hose，the other end would be in water tank or
water channel.
· If ambient Temp.
follow below sequence: if ambient Temp.
compressor stops；when it reaches ≥17℃，compressor
starts again.（There would be a 3-min delay for
Compressor protection）
· Fan runs with a fixed low speed.
· Temp. is fixed.
(Notes：Under dry mode，please dismantle air exhaust duct，or
performance will be affected and water full alarm"FL"will buzz.)
Heating Mode (not available for cooling only model)
· Under this mode, heating indicator will light up.
· Press UP/DOWN button to select Temp. between 16℃ and 30℃.
· Press Fan Speed button to set low/ high speed.
Operation
≥17℃（or
62℉）compressor starts and
≤15℃ (or
59℉）
14