Publicidad
Idiomas disponibles
Idiomas disponibles
Assembly
1. Flush through the supply pipes.
2. Place the mixer including the sealing washer in
position on the sink. Hole Ø 34 mm!
3. Slip the plastic washer, the slide washer, the
metall washer and collar nut over the hose and
threaded base and tighten the collar nut by
hand. If there is not enough space, please use
only the slide washer and the metall without the
plastic washer.
4. Tighten screws.
5. Connect the back flow preventor cartridge to the
angle valve. Connect the connecting pip to the
back flow preventor cartridge (see page 4).
6. Connect the hose with hose nut, taper sleeve, disc
and washer (see page 4).
7. Mount the hose weight - be careful by the max.
drawn out, otherwise the hose could be crack.
Large differences in pressure between the hot and cold
water supply should be balanced.
Operation
The mixer is actuated by lifting the lever head.
Swivel to the left = hot water,
swivel to the right = cold water.
The handspray can be drawn approx. 50 cm out of the
arm lining.
Technical Data
Recommended operating pressure: 1 - 5 bars
Hot water temperature:
Recommended hot water temperature: 65° C
Rate of flow:
anti-pollution function
Attention!
With water heaters of 5 liters the flow rate at the
mixer should not exceed 5 l/min.
In this case the flow rate must be reduced at the
angle valve.
When the storage tank is being heated, the spout
will drip.
When changing the spray former, it is imperative to
use one made for this type of mixer.
7
English
Spare parts
1
1.1 screw cover
2
3
4
5
6
7
8
9
10
11
XXX = Colors
000 chrome plated
030 chrome plated/blue
060 chrome plated/black
090 chrome plated/gold plated
450 white
610 black
750 alux
880 satin chrome
max. 80° C
5,0 l/min 3 bars
handle
flange
nut
service set
seals (5)
mixer ball
hose
handspray
spray former cpl.
fixation cpl.
back flow preventor cartridge
fixation extension 35 mm
16891XXX
94186000
13919XXX
13918000
13953000
13967000
13966000
96200000
13892XXX
94033000
13961000
95051000
13898000
7
Publicidad
