Publicidad
BEFORE REQUESTING SERVICE
WARNING
Disconnect the electrical supply before servicing or cleaning the vacuum cleaner.
Failure to do so could result in electrical shock or personal injury from vacuum
cleaner suddenly starting.
Review this chart to find do-it-yourself solutions for minor performance problems.
Any service needed, other than those described in these Operating Instructions,
should be performed by an authorized service representative.
PROBLEM
Vacuum Cleaner
won't run.
Poor job of dirt
pick-up.
Light won't work.
Agitator not turning
Air flow restricted
with attachment use.
Sound changes.
Electrical Shock or Personal Injury Hazard
POSSIBLE CAUSE
1. Unplugged at wall outlet.
2. Tripped circuit breaker/blown
fuse.
3. On /off switch not turned on.
1. Full or clogged dust bag.
2. Worn agitator.
3. Clogged nozzle or bag holder.
4. Clogged hose.
5. Hole in hose.
6. Broken/misplaced belt.
7. Hose not inserted fully.
8. Motor protection system
activated.
9. Dirty filters.
1. Burned out light bulb.
1. Broken belt.
2. Belt installed incorrectly.
1. Attachment use restricts
air flow.
2. New carpet fuzz clogged
air path.
1. Plug in firmly, push on/off
2. Reset circuit breaker or
3. Push on/off switch to on.
1. Change bag.
2. Replace agitator.
3. Check CLOG REMOVAL.
4. Check for clogs.
5. Replace hose.
6. Replace/fix belt.
7. Insert hose fully.
8. Check for clogs.
9. Change filters.
1. Change light bulb.
1. Replace belt.
2. Check BELT CHANGING
1. Check ATTACHMENTS.
2. Check CLOG REMOVAL and
- 49 -
POSSIBLE SOLUTION
switch to on.
replace fuse at household
service panel.
AND AGITATOR CLEANING.
clean hose.
Publicidad
