Publicidad
Idiomas disponibles
Idiomas disponibles
Powerboost function
The Powerboost function can be used to heat large amounts of
water more quickly than the power level
Usage restrictions
This function can always be activated for a hotplate, provided
the other hotplate in the same group is not in use (see
illustration). Otherwise,
˜
display; the
heat setting is then set automatically.
Š
Time programming function
This function may be used in two different ways:
to automatically switch off a hotplate.
■
as a timer.
■
A hotplate should switch off automatically
The hotplate switches off automatically after the time that is set
has elapsed.
Set the cooking time.
The hob must be switched on.
Use the twist knob to select the hotplate and the required
1.
heat setting.
Touch the
3
symbol.
x
2.
hotplate.
‹‹
appears in the timer function display.
Use the twist knob to select the required cooking time.
3.
After a few seconds, the cooking time begins to elapse.
Notes
The same cooking time can be set automatically for all
■
hotplates. The set time for each of the hotplates counts down
independently.
The Basic settings section contains information on
automatically programming the cooking time.
If the combi zone or move function is selected when the
■
hotplates are combined, the set time is the same for both
hotplates.
Š
.
and
flash in the heat setting
Š
lights up in the display for the
Note: In Group 1, the powerboost function can only be
activated if the two hotplates are used independently of each
other.
To activate
Select the hotplate using the Tipp control.
1.
Press the
˜
symbol.
2.
The function has been turned on.
To turn off
Select the hotplate using the Tipp control.
1.
Press the
symbol.
˜
2.
The Powerboost function has been deactivated.
Note: In certain circumstances, the Powerboost function may
turn off automatically in order to protect the electronic
components inside the hob.
Changing or cancelling the time
select the hotplate using the Tipp control. Press the
and change the cooking time using the Tipp control, or set to
‹‹
.
Once the time has elapsed
The plate is turned off. The warning signal sounds, the hotplate
displays
‹
and the time program function screen displays
‹‹
for one minute. The
x
Pressing any symbol turns off the indicators and stops the
beep.
Notes
If cooking times have been programmed for various plates,
■
the time program function displays the shortest cooking time.
The
indicator of the hotplate lights up.
x
To check the remaining cooking time of a hotplate: select the
■
hotplate using the Tipp control. The cooking time will be
displayed for five seconds.
Cooking time can be programmed for up to 99 minutes.
■
The timer
The timer can be set for periods of up to 99 minutes. It is
independent of the other settings. This function does not
automatically switch off a hotplate.
How to program
No hotplate should be selected.
Press on the
symbol, and the time program function
3
1.
display shows
.
‹‹
Select the required time using the Tipp control.
2.
The timer starts to count down after a few seconds.
Changing or cancelling the time
Press the
3
symbol and change the time using the Tipp
control, or set to
.
‹‹
Once the time has elapsed
A warning beep sounds. The time program function displays
‹‹
and the indicator
V
comes on. Pressing any symbol turns
off the indicators and stops the beeping.
3
indicator of the hotplate flashes.
symbol
27
Publicidad
