Dreame DreameBot D10s Manual De Usuario página 12

Before Use
EN
1. Remove the protective strips
2. Install the side brush
Click
Note: Install the side brush until it clicks into place.
10
3. Set up the charging dock
Peel off the double-sided tape at the bottom of the charging dock, then
place the dock on the level ground against the wall and connect it to a
power outlet.
Within the Good
Wi-Fi Range
Note:
· Keep the immediate area 1.5m in front of the charging dock and 0.5m to its
both sides clear of objects.
· Do not place the charging dock in an area with direct sunlight or where other
objects might block the signal, as this may hinder the robot from returning to
the charging dock.
· Please clean the floor area where the charging dock will be placed with a dry
rag.
· Use of the double-sided tape is based on your need.
· If necessary, remove the double-sided tape slowly to reduce adhesive residue.
4.Place the robot onto the charging dock to charge
Note:
· Fully charging is recommended before first-time use. This ensures that the
robot returns to the charging dock successfully.
· Do not move the the charging dock while the robot is cleaning.
＞ 0.5 m
＞ 0.5 m
＞ 1.5 m