Makita DCL181F Manual De Instrucciones página 14

MAINTENANCE
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before attempting to perform inspection or
maintenance.
After use
NOTICE:
Putting the cleaner against the wall
without any other support cause the cleaner to
fall down and be damaged.
► Fig.37
Cleaning
NOTICE:
Never use gasoline, benzine, thinner,
alcohol or the like. Discoloration, deformation or
cracks may result.
NOTICE:
Do not blow dust sticking on the
cleaner and filters by air duster. It brings dust into
the housing and causes failure.
NOTICE:
After washing filters, dry them thor-
oughly before use. Insufficiently dried filters may
cause poor suction and shorten the service life of the
motor.
NOTICE:
After cleaning filters and sponge filter,
be sure to re-install them before use. If you use the
cleaner without filters and sponge filter, dust comes
into the motor housing and cause malfunction.
Cleaner body
From time to time wipe off the outside (cleaner body) of
the cleaner using a cloth dampened in soapy water.
Clean out also the suction opening and filter mounting
area.
► Fig.38
Troubleshooting
Before asking for repairs, check the following points.
Symptom
Weak suction power
Not working
CAUTION:
Do not attempt to repair the cleaner by yourself.
To maintain product SAFETY and RELIABILITY, repairs, any other maintenance or adjustment should be performed
by Makita Authorized or Factory Service Centers, always using Makita replacement parts.
Filter
Wash the filter in soapy water when it is clogged with
dust and the cleaner power becomes weak. Dry it out
thoroughly before use.
► Fig.39
Sponge filter
When the sponge filter becomes dirty, clean it as
follows.
1.
2.
3.
you wash it, dry it out thoroughly before use.
4.
and set it in the original position. Make sure that each
bottom edge of the pillar holds down the sponge filter,
and there is no gap between the sponge filter and suc-
tion opening.
► Fig.40: 1. Sponge filter 2. Bottom edge of pillar
Wall mount for cordless cleaner
Optional accessory
NOTE: The screw to mount the holder is not included.
Prepare a screw which fits with the material to screw
into.
Attach the wall mount for cordless cleaner to a hard
wooden wall, beam or column, where the wall mount
for cordless cleaner can be firmly secured. Always be
sure that the wall mount for cordless cleaner is securely
attached before hanging the cleaner.
► Fig.41: 1. Wall mount for cordless cleaner
mount violently or hang other appliances than the
cleaner.
Area to be investigated
Is the capsule full of dust?
Is the filter clogged?
Is the battery cartridge exhausted ?
Is the battery cartridge exhausted ?
14 ENGLISH
Remove the filter.
Pull out the sponge filter from between the pillars.
Clean the sponge filter by tapping or washing. If
Insert the sponge filter from between the pillars
CAUTION:
Do not hang the cleaner to the wall
Empty the capsule of dust.
Clean or wash the filter.
Charge the battery cartridge.
Charge the battery cartridge.
Fixing method