Publicidad
Idiomas disponibles
Idiomas disponibles
LOWER THE TOP HEATING ELEMENT
(ONLY IN SOME MODELS)
1. Remove the lateral shelf guides.
1
2
2. Pull the heating element out a little and lower it.
REMOVING AND REFITTING THE DOOR
1.
To remove the door, open it fully and lower the
catches until they are in the unlock position.
2.
Close the door as much as you can.
Take a firm hold of the door with both hands – do not
hold it by the handle.
a
Simply remove the door by continuing to close it
while pulling it upwards at the same time until it is
released from its seating. Put the door to one side,
resting it on a soft surface.
~15°
a
3.
Refit the door by moving it towards the oven,
aligning the hooks of the hinges with their seating
and securing the upper part onto its seating.
b
b
3. To reposition the heating element, lift it up, pulling
it slightly towards you, making sure it comes to rest
on the lateral supports.
4.
Lower the door and then open it fully.
Lower the catches into their original position:
Make sure that you lower them down completely.
a
Apply gentle pressure to check that the catches are in
the correct position.
"CLICK"
5.
Try closing the door and check to make sure that it
lines up with the control panel. If it does not, repeat
the steps above: The door could become damaged if
it does not work properly.
b
EN
11
Publicidad
