Rohde ST 310 Instrucciones De Uso página 60

5.3.3. Firing program sequence
No. Description
After the program delay t
1
elapsed, the firing program starts.
The temperature rises at the first
entered, ascending ramp rate
2
Rmp until the first switch point
1
Tmp .
1
After the first switch point, Tmp
the kiln continues with the second
entered, ascending ramp rate
3
Rmp (heating up) until the kiln
2
reaches the end temperature,
Tmp .
2
After reaching the end temperature
Tmp , the kiln remains at this
2
temperature for the set soak
period t .
2
The controller then executes the
3 cooling rate Rmp
3
the program is reached.
5.4. Programming the control unit
5.4.1. Changing the firing program
No. Display Indicator
20
0
Pr. 1
1
Pr. 2
2
Remarks
has
0
If no program delay is entered, the firing program starts immediately.
⇒ The ramp rate is settable in the range between 1 °C/h and
999 °C/h or as FULL (full load heating) or END (program end).
⇒ If the entered temperature Tmp
chamber temperature, Rmp
skipped in the firing program when the program starts, and the
controller starts at the second heating rate, Rmp
,
1
⇒ The ramp rate is settable in the range between 1 °C/h and
999 °C/h or as FULL (full load heating) or END (program end).
⇒ The temperature is settable over the range of 0 °C to 1400 °C
(depending on the kiln model and its maximum temperature).
⇒ The soak period is settable over the range 00:00 (no soak) to 99
hours 59 mins.
⇒ During soaking, the controller display alternates every 15
seconds between kiln temperature and soak period remaining.
until the end of
Meaning
No program in operation
Select program memory
Select program number
58 / 293 - EN -
is lower than the current firing
1
and Tmp are automatically
1 1
Description
•
If no firing is being performed, no indicators
will light up.
•
The main display shows the current firing
chamber temperature.
X
Press the key to select the program memory
for the firing programs.
d f
•
Press the and
desired program number.
g
•
Press the key to select the program
number to be changed.
.
2
keys to select the