Rohde ST 310 Instrucciones De Uso página 64

5.5.3. Additional functions
Function
Program delay "t "
0
Program advance function
Y
Program pause facility
Z
5.6. Cooling/end of the firing process
After firing, the kiln is switched off below 150°C and starts to cool down on its own.
Display screens:
Condition Display 1
149 HOt
Below 150°C &
above 40°C
Below 40°C &
room
temperature
Description
You can use the program delay "t
with a time delay (at a specific time). Please refer to Section 6.1.3.
Press and hold the
function during firing. The controller will emit a short beep and immediately
advances the program by one step. Please refer to Section 6.1.4.
Activate the program pause function by pressing and holding the
seconds). The controller sounds a short beep, the current program is paused,
and the current kiln temperature is maintained. Please refer to Section 6.1.5.
Display 2
39 En d
" or program delay to start the firing program
0
Y
key for 3 seconds to switch to the program advance
Program section
62 / 293 - EN -
Z
key (for 3
Description
⇒
As long as the kiln
temperature is below 150 °C
and above 40 °C, the display
alternates between display 1
and 2 every 5 seconds.
⇒ Alternatively, you can end the
firing by pressing the
⇒ As soon as the kiln has
cooled below 40 °C, the
display alternates between
displays 1 and 2 every 5
seconds.
j
⇒ By pressing the key, you
can now put the controller
into an idle state. The
controller is now ready for a
new firing (or the device can
be switched off).
j
key.