Rohde ST 310 Instrucciones De Uso página 82

10.3. Changing parameters
Step Display
1
8.8.8.8.
2
F 1.0 0
2
tC.S
3
tC.S
4
P14-
5
P60-
6
0
7
1
8
1
9
10
20
11
11. Cleaning the control unit
11.1. General safety information
CAUTION
The control system and the kiln must not be cleaned with a water jet, water hose or high-
pressure cleaner.
⇒
⇒
Description
Switch off the control unit.
Switch on the control system and
simultaneously press the
Continue to hold down the
j
Hold down the key until the type of
thermocouple set is shown on the main
display.
j
Now release the key.
The main display shows the first
configurable parameter.
d
By pressing the and
can select the parameter to be
configured.
g
With the key, you can call up the set
value of the parameter to be configured.
d
By pressing the and
can change the value.
You can save the value with the
The control system display will go dark
for 2–3 seconds, and the control
system will restart automatically.
After the restart, the control system is
ready for normal operation again.
Do not use water or compressed air for cleaning. The possible consequences are:
­ Damage to components
­ Impairment of functions
­ Failure of the control system and kiln
Always clean the control unit and kiln dry.
80 / 293 - EN -
Remark
j
key.
j
key.
The thermocouple type is only displayed
and cannot be changed here. The
thermocouple is preconfigured at the
factory.
f
keys, you
f
keys, you
j
key.
The set value is now permanently saved
for the respective parameter.